[. . . ] A) If your appliance comes fitted with a plug, it will incorporate a 13 Amp fuse. If it does not fit your socket, the plug should be cut off from the mains lead, and an appropriate plug fitted, as below. WARNING: Very carefully dispose of the cut off plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard. [. . . ] OPERATION MODELS WITHOUT TIMER Summer use (ventilation only): turn the knob clockwise to the position. Setting the thermostat: when the room temperature has reached the desired level, slowly turn the thermostat dial counter-clockwise until the pilot light goes out (or until you hear a `click' on models without pilot light) but no further. MODELS WITH 24 HOUR PROGRAM UNIT (TIMER) In order to program the heating function, proceed in the following manner: Look at your watch. If it, for example, indicates that the time is 6 PM (18 hours), then turn the numbered disk of the program unit clockwise until the number 18 lines up with the reference marker on the face of the timer. Set the time periods in which the appliance is to function, pulling out the pins of the timer. At this point you will see the sectors which correspond to the functioning times. Once the appliance is set in this manner, it will function automatically every day during the programmed periods. Important: In order to maintain the programming, it is necessary to keep the electric plug inserted in the electric socket. In order to change the programming, put the pins back into their original positions and set the functioning periods from scratch. Bypassing the program: In order that the appliance functions outside of the programmed periods, pull out all of the timer's pins. Anti-freezing feature: With the knob of the thermostat in position , the appliance maintains the room at a temperature of about 5°C, thus preventing freezing with a minimal expenditure of energy. MAINTENANCE Always pull the plug out of the power point before cleaning the heater. Periodically clean the air intake and outlet grilles during the period in which the heater is in use with a vacuum cleaner. WARNINGS Do not use the appliance in the vicinity of showers, bath tubs, wash basins, swimming pools, etc. [. . . ] The heater is fitted with a safety device which will switch off the heater in case of accidental overheating (eg. Obstruction of air intake and outlet grilles, motor turning slowly or not at all). To reset, disconnect the plug from the power for a few minutes, remove the cause of overheating then plug the appliance in again. [. . . ]